Comdial FX Series Especificações descarregar pdf (Página 50)

Federal Communications Commission (FCC)

and Industry Canada (IC) Rules and Regulations

FCC Part 15 RF Emission Information

This equipment contains incidental radio frequency generating circuitry and, if not installed and used

properly, may cause interference to radio and television reception. This equipment has been tested

and found to comply with the limits for a Class A computing device pursuant to Subpart J of Part 15

of the FCC Rules. These limits are designed to provide reasonable protection against such

interference when operated in a commercial environment. Operation of this equipment in a

residential area may cause interference to radio and television reception; in which case the user is

encouraged to take whatever measures may be required to correct the interference. If this equipment

does cause interference to radio and television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures: reorient the television or radio receiving antenna, and/or relocate the system,

the individual telephone stations, and the radio or television with respect to each other. If necessary,

the user should consult the manufacturer or an experienced radio/television technician for additional

suggestions. The user may find the following booklet prepared by the Federal Communications

Commission helpful: “How to Identify and Resolve Radio-TV Interference Problems.” This booklet

is available from the Government Printing Office, Washington, DC, 20402. Stock No.

004-000-00345-4.

FCC Part 68 Information

This equipment complies with Part 68 of the FCC Rules. A label, located on the exterior lower left

side of the cabinet, contains the FCC Registration Number(s) and Ringer Equivalence Number

(REN).

Notify the local telephone company when you connect the equipment to the network and provide the

information shown in the following table:

Line Type

Service Order

Code*

Facilities Interface

Code*

Ringer Equivalence

Number*

Universal Service

Order Code

Connector

Loop Start 9.0F 02LS2

See Equipment

Specification Sheet

RJ21X

Ground Start (See note) 9.0F 02GS2

See Equipment

Specification Sheet

RJ21X

DID Lines 9.0F–AS.2 02RV2–T Not Applicable RJ21X

E&M Lines 9.0F TL11M

See Equipment

Specification Sheet

RJ2EX

T1 Line 6.0Y 04DU9–1SN Not Applicable RJ48C

T1/PRI (ISDN) Line 6.0Y 04DU9–1SN Not Applicable RJ48C

NOTE: State tariffs do not permit ground start operation for KF registered equipment (key system

operation). Ground start operation is only permitted for MF registered equipment (KTS/PBX

hybrids with both manual and pooled outgoing and incoming access to the network). The

system must

be configured for MF operation when using ground start operation.

* Refer to the paragraph titled Terms and Definitions for detailed explanations.

46 – Knowing the Specifications

GCA40–242 General Description

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 171 172

Comentários a estes Manuais

Sem comentários

Comdial FX Series Especificações Página 50

Comentários a estes Manuais

Manuais e produtos relacionados com Atendedores de mensagens Comdial FX Series