Comdial FX Series Especificações descarregar pdf (Página 121)

Manual Exclusion

Refer to the discussion titled Privacy Release.

Manual Reset

The system provides a button on the central processor unit circuit board for manually resetting the

software. When someone presses this button, it causes the system to reset all lights, features, line

states and station states.

Mark Problem Line

System users can mark a line that is not functioning properly as a problem line. They do this by

dialing a feature code or pressing a pre-programmed button. After users have marked a particular

line a programmed number of times, the system takes the line out of service (unless programmed to

prevent this from happening). When the system takes the line out of service, it logs the condition and

triggers an alarm. The printed error log will then show which line is out of service and so will the

displayed error log. An out of service line is only out of service for line group use; it is available for

direct selection or prime line access. Further, an out of service line is available for all inbound calls

unless it is a DID line. The CO will not send a call over a disabled DID line. Users can not mark a

line during a conference call or when they are DISA callers. When users mark a line during an active

call, the system records the mark for the active line. If users take marking action during an idle

condition, the system records the mark for the last active line (this includes lines that are presently

on hold).

System users can use the line disable feature at the installer’s station to restore service on the out of

service line. installers can restore service to individual disabled lines or they can take action to

restore service to all marked lines in the system if they wish.

Understanding the Features – 117

General Description GCA40–242

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 171 172

Sem comentários

Comdial FX Series Especificações Página 121