Comdial FX Series Especificações descarregar pdf (Página 8)

FX II System Installation and Maintenance

GCA39-823 Rev 1, Issue 9/01 Page 2 Printed in the USA

Preparing for Installation

Hardware Tools Recommended for System Installation

• All of the tools below are recommended during a FX II installation.

• It is always a good idea to install, initialize, and test the FX II system before transporting it to

the installation site.

• Comdial includes all the necessary screws for system and board installation for the FX II.

Hardware Tools Listing

Round-head wood screws

(typically 1/4 x 1–inch)

To mount equipment cabinet to backboard.

Round-head wood screws

(typically 1/4 x 1 ½–inch)

To mount backboard to wall studs; longer screws are

necessary if fasteners must also pass through a dry-wall

covering.

Cross-recessed screwdriver

(#2 Phillips-head type)

To match flat head screws that attach universal

mounting brackets to cabinet.

Electric drill If prepared holes are required.

Connecting tool To fasten wires to a type-66 connector block.

Crimping tool For 623-type modular plugs.

Static discharge and conductive floor mat

Grounding Considerations

• Circuit boards for the Impact FX II system are susceptible to damage caused by electrostatic

discharge, and you must keep this fact in mind as you handle the system backplane and line

and station circuit boards.

• Refer to the Comdial publication IMI01-005,” Handling Of Electrostatically Sensitive

Components” for general information specific handling precautions are also included in this

installation instruction.

• Note that if a static discharge wrist strap and conductive floor mat are not available, you must

take precaution of discharging any electro-static build up by touching a grounded metal

cabinet or power supply.

Environmental and Mounting Conditions for Systems

• You must select a suitable location to mount the FX II system. A suitable location must be

chosen based on the following requirements:

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 251 252

Sem comentários

Comdial FX Series Especificações Página 8